Ender 3 S1 COREXZ - voron cube 17m34s

Still a lot of room for improvement but printing at really high speeds with better quality than stock. Maximum speed I saw on klipper was 199mms as the voron cube is rather small.
This is not sustainable as the XZ stepper motor mounts are printed in PLA could risk the plastic softening.
Will use with reduced speeds until I print some more rigid PETG mounts. - 17m34s at really good quality - 0.2mm layer height - external perimeter speed 200mms - other 300mms - 0.2 z-hop - esun mat pla

Источник: rutube.ru